Salt Inhibitor

Dust-free, clean, free from substances that could impair adhesion (oil, wax, grease etc.)

Remove coatings, renders and whitewashes at least 80 cm above the upper edge of the masonry salt or damp.

Use a dry brush to remove any visible salt.

Rake out damaged mortar joints to a depth of at least 2 cm.

Apply the material in sections, under gravity and without misting in the flow coating procedure, horizontally from top to bottom.

Repeat the procedure (wet-on-wet) until no more material uptake is observed.

Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.

Immediately remove excess product.

Perform subsequent operations wet-on-wet, within the reaction time.

Broom, ceiling brush, K-surface sprayer with a wide jet spray nozzle

Clean tools with water while the material is still fresh.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

Approx. 0.4 - 0.6 kg/m²

Not suitable for improving surfaces where higher requirements are placed on appearance.

The relevant test certificates must be observed when planning and carrying out work.

The applicable regulations and legal requirements must be observed.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.