Induline V-Joint Protection

Prime building elements and apply an intermediate coating by means of flow coating if necessary.

Intermediate sanding: P 220 - 240, remove sanding dust.

The nozzle tip may need to be cut at an angle in order to create an opening for properly measuring out the material. Position the tip on the open joint and apply with gentle pressure, leaving a slight excess. Smooth off the material with your finger (wear gloves). Once the material has dried, apply the next coating.

Seal opened containers well and use contents as soon as possible.

Check colour, adhesion and compatibility with the substrate by setting up a trial area.

If you intend to use this product in a different way in the coating process, please discuss this with the RTS (Remmers Technical Service) in advance.

In order to ensure that all material can be emptied out of the container, it is recommended to stand it on its head during the application process (secure the tip with a lid).

Ready for overcoating: after approx. 1 hour, depending on the application quantity

Practice values at +20 °C and 65% relative humidity.

Low temperatures and high humidity delay drying.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

Approx. 10 ml/running metre for a 2 mm V-joint

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.