WP Sulfatex

Clean, dust-free and capable of supporting a load.

Pre-wet highly absorbent substrates.

Remove render and/or coatings at least 80 cm above the damaged area.

In the floor-wall connection remove screed for a width of approx. 20 cm.

Break off or chamfer corners and edges.

Coves must be rounded out.

W1-E: seal pipe penetrations by using the product to form a cove around them.

Salt inhibitor

Pre-treat salt-contaminated substrates with Sulfatex LQ and Salt IH.

Exterior priming:

Prime mineral substrates with Kiesol (1:1 with water)/Kiesol MB.

Interior priming:

Prime mineral substrates with Kiesol (1:1 in water).

Waterproofing in drinking water areas

Apply three layers of material to the prepared, pre-wetted substrate without priming.

Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C

Apply at least two layers of the material.

Bonding layer before render application
Apply another slurry layer of the product and apply render wet-on-wet.

Alternative: apply a slurry layer of the product, throw on SP Prep, apply render once dry.

Do not use in direct sunlight.

The maximum total wet coat thickness must not exceed 5 mm.

Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

Protect the fresh waterproofing layer from rain, direct sunlight, frost and condensation water.

Once dry, protect from mechanical damage.

Please contact Remmers Technical Service (phone +49 5432 83900) before applying with machine processing.

Mixer, ceiling brush, slurry broom

Clean tools with water while the material is still fresh.

If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

Approx. 1.6 kg/m²/mm layer thickness

Layer thicknesses and application rate for subsequent interior and exterior waterproofing

The mixing water must be of drinking water quality.

May contain traces of pyrite (iron sulphide).

Low chromate content in accordance with Directive 2003/53/EC.

Always set up a trial area/trial areas first.

The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

The relevant test certificates must be observed when planning and carrying out work.

Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

Special agreements and certificates of suitability can be downloaded online at www.remmers.com.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.