IG-10 Impregnation Primer IT

The substrate must be clean, dust-free and dry.

Dimensionally stable wood building elements: wood moisture content 11-15%

Wood building elements with limited or no dimensional stability: wood moisture content max. 18%

Thoroughly remove any dirt, grease and non-adhering old coatings.

Take appropriate measures to protect adjacent building elements and materials that should not come into contact with the product.

Observe BFS Code of Practice No. 18 "Coatings on Wood and Wooden Working Materials in Outdoor Areas".

Temperature of material, surroundings and substrate: min. +5 °C - max. +30 °C.

Stir well.

Qualified specialist companies: brushing, dipping, flow-coating and spraying in closed systems only.

Seal opened containers well and use contents as soon as possible.

Check colour, adhesion and compatibility with the substrate by setting up a trial area.

Can be overcoated after approx. 24 hours

Practice values at +20 °C and 65% relative humidity.

Low temperatures, poor ventilation and high humidity delay drying.

After drying, the treated wood can be finished with acwater-based or solvent-based coating system.

If a water-based finish is used, overnight drying is required.

Ready to use

Paintbrush with natural bristles, flat brush, dipping tank, spraying tunnel

Clean tools immediately after use with V 101 Thinner.
Dispose of the remains from cleaning properly.

Store in well-sealed, original containers, out of the reach of children and in a dry, cool, well-ventilated room which is protected from direct sunlight and frost. No smoking is permitted in storage areas.

Preventive protection against blue stain, soft rot, insects and termites at 150 ml/m²

According to the current state of the art (this includes DIN 68800-1 and -3 in Germany), wood preservation measures must also be planned for non-load-bearing wooden elements in good time and with due care, with the agreement of all parties involved in the construction (architect, developer, builder) and in compliance with the legal requirements and the conditions on site. The use of biocidal (“chemical”) wood preservatives should therefore always be indicated in suitable fashion prior to sale, or must be agreed in advance with the client in writing. Failure to comply with this requirement may result in country-specific or contract-specific conflicts with legal requirements, standards or certification systems. The Remmers Technical Service would be happy to discuss the matter and provide you with a template agreement for the use of a biocidal (“chemical”) wood preservative on the wooden elements being used.

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

European waste code 03 02 99 wood preservatives not otherwise specified

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.